Cricut Maker Wood State Ornament

I recently bought my first Cricut Maker and I was super excited to test it out using the Knife Blade and some Basswood. The season got to me and I wanted to make some State Love wooden ornaments.

Keep reading if you want to make these cute ornaments…and I’ve even created a free SVG download of every state ready for your use! https://mailchi.mp/3c2c9730af54/px57ire3kt

Materials Needed

Cricut Maker
Knife Blade (Sold Separately)
Cricut StrongGrip Mat
Blue Tape
Basswood (I used a 1/16″ x 4″ x 24″ board that I bought from Menards)
String

Steps

Upload your state design (https://mailchi.mp/3c2c9730af54/px57ire3kt) into Cricut Design Space. If you want to create your design from scratch just follow the video instructions below.
Click “Make It” and be sure to set your settings to 1/16″ Basswood (or whatever wood you use)
Place your basswood onto your StrongGrip Mat and tape down the sides with blue or masking tape for extra security.
Load your Knife Blade and click “Go” on your Maker. As the design is cutting dont forget to remove loose pieces of wood or tape to make sure there are no interruptions with the cut.
When the cut is complete, remove the tape and test to see if your design comes out easily. If there is any resistance then replace the tape and allow for one more pass on the Maker.
After the cut is complete use any tools (I used tweezers) to slowly and carefully remove the wood ornament.
Tie a small string through the hole and it is ready to hang!